Driveshaft Shop
DSS 2020 C8 Corvette 1400Hp Level 5 Axle
* Images may be a representation and may not reflect the actual product.
Product Details
DSS 2020 C8 Corvette 1400Hp Level 5 Axle RA5310X6
Vehicle Fitment
Please verify year, make, model, and any notes before ordering.
- 2020-2024Chevrolet Corvette
Product Specs
- Brand
- Driveshaft Shop
- Part Number
- 510312
- Catalog Number
- 001348150
- Product Line
- Level 5 Dom Axles
- Category
- Drivetrain
- Type
- Axles
- UPC / Barcode
- RA5310X6
- Vendor Product Category
- Drivetrain
- Vendor Product Subcategory
- Axles
- Length
- 41.00 in
- Width
- 5.20 in
- Height
- 4.70 in
- Weight
- 21.20 lb
- Units Per SKU
- 1
- Freight / LTL
- No
- Air Restricted
- No
- Prop 65
- Unknown
- CARB Approved
- Yes
- Clearance Item
- No
Shipping & Availability
This item is showing available inventory. Most in-stock performance parts ship quickly, but timing can vary by warehouse, vendor cut-off time, holidays, and carrier pickup.
PROP 65 WARNING: This product can expose you to chemicals, which are known to the State of California to cause cancer or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Inventory shown: 2 available as of 6/4/2026.
All axles and drive shafts covered under warranty by The DriveShaft shop are for repair only.
lease understand the axles cannot be returned for any reason unless it is within the warranty period, or an incorrect part was sent. In the case of an incorrect part it is the installers sole responsibility to determine if the part is correct or not, if an incorrect part is installed and either damages the axles or any other parts, it is the sole responsibility of the installer and absolutely no repair under warranty will be given nor reimbursement for loss of time or monetary cost.
Level 0 axles have no warranty against breakage.
1. Warranty for level 2 units are 6 months from date of purchase, axle is covered for repair only and only for the covered period. (Unless noted on invoice). DriveShaft shop and its distributors may not be held responsible in any way for loss of time, loss of money or reimbursement for damage caused by the products
2. Warranty for Levels 2.9, 3, 3.9, 5, 5.9 and all drive shafts are 12 months from date of purchase. The axle or drive shaft is covered for repair only and only for the covered period (unless noted on invoice). DriveShaft shop and its distributors may not be held responsible in any way for loss of time, loss of money or reimbursement for damage caused by the products
3. Absolutely no axle or drive shaft will be returned unless it is a new unit that has not been installed and is returned in original box with copy of original sales receipt and return authorization number. Returns are for credit only, NO EXCEPTIONS. Authorized returns are subject to a 10% restocking fee. Credits are for parts only and we do not refund shipping and handling charges on any returns.
4. Ripped boots are not covered under the warranty; this is considered a road hazard and any damage caused by ripped boots will not be covered under the warranty.
5. Axles purchased from The DriveShaft Shop or its distributors are covered for repair of the unit purchased only. These are performance products and should be installed by certified professionals, The DriveShaft shop and its distributors may not be held responsible for loss of money, time or inconvenience caused by the use of our products and by installing the unit you are agreeing to all of these terms and release The DriveShaft Shop and its distributors of any and all liability and waive the right to all and any law suit that may arise from the use of these products.
6. Any custom made Axle or Drive shaft is non-refundable. We will do everything in our power to help make the part fit or work correctly, but there will be no returns or refunds on "custom" parts.
7. Any aftermarket or custom drive train part attached to our axle/drive shaft will release "The Drive Shaft Shop" of any liability or warranty claim. There will be no exceptions to this.
Reviews & Questions
Real product feedback when available, plus quick ways to get fitment or product help.
Other Popular Parts
The Driveshaft Shop has been designing driveshafts used in racecars and street performance cars for over 30 years. Driveshafts can be ordered in carbon fiber, Aluminum and Chromoly. LMPerformance carries all of the Driveshaft Shop products including driveshafts, conversion plates, axles, input shafts and more.
The Driveshaft Shop dynamically balances every drive shaft at over 9000 RPMs for unsurpassable dependability and we want to let you know why that is so important. Most balancing machines depend on sensors that determine the “weight centerline” of the spun part and this then gives the information that is needed to determine how much weight is then necessary to bring it with the required tolerance. However, if the shaft can be spun at the actual speed it will be used at it can provide significantly more information affording the opportunity to make a much more precise correction, and an additional significant advantage is that The Driveshaft Shop’s high-speed balancer can analyze parameters such as joint tolerance, tube flex, harmonic resonance, slip yoke instability and more, all extremely important and helpful in making the drive shaft as precise as possible. Many balancing machines only spin anywhere from four hundred to three thousand RPM but this new balancer that The Driveshaft Shop had custom made is exceptional because of its ability to dynamically balance at over nine thousand RPM’s. Now let’s talk about the differential and we are sure all you racing aficionados know this but some of you enthusiasts new to racing my want a little help. When your car corners the inner wheel travels a shorter distance than the other wheel and if your car did not have a differential the result would be either an inner wheel that rotates much too fast or the outer wheel would drag and that is certainly not something you want because then your car would be extremely difficult to handle, and you would experience tire damage or possible drive train failure. But what if you are in the performance arena and don’t want cornering difficulties such as the inside wheel spinning while hard on the gas in your powerful Corvette, Charger or 300C then you need a limited differential and you will find one by The Driveshaft Shop below that is of inimitable quality, and because it allows for a limited amount of clutch slip between each axle side you will experience relatively small differences in rotation when you take that corner and will prevent dangerous wheel spin. See all transmission products by The Driveshaft Shop including driveshafts, axles, and conversion plates on our website and let us help you get your drive shaft in perfect working order at a competitive price and with free shipping.
Review our return, cancellation, shipping, warranty, and product image policies before ordering.
Contact us with questions before ordering
California Residents: Prop 65 WARNING: This product MAY contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. For more information, visit www.P65Warnings.ca.gov
California Residents: TIRE WARNING: LMPerformance will not ship Tires to California.
Legal: Some or all of these parts may not comply with Federal, State, Province, and/or Local laws, ordinances, and regulations. Buyer takes all responsibility to ensure that any modifications or upgrades that have done conform to all applicable laws and regulations for road use, especially pertaining to safety and emissions. LMPerformance is not responsible for buyer not complying with Federal, State, Province, and/or Local laws, ordinances, and regulations. This policy shall be in force for all past, current, and future purchases from LMPerformance, Inc. LMPerformance will not ship ANY non-CARB compliant products to California where California requires products to be CARB certified such as Catalytic Converters and Induction Kits.
Free Shipping: Please note FREE Shipping refers to shipping within the contiguous continental US only. All other locations extra. Some items that require Truck Freight Delivery will require a Truck Freight surcharge. This surcharge is still a discounted shipping amount that is lower then the actual truck freight shipping charge that is charged to LMP. LMP will try to still give the lowest price possible for truck freight items.
Images: Images may be a representation and may not reflect the actual product. Examples would be SPEC stage 3 clutch kits which all use the same photo.
TYPOS: LMPerformance tries to present the best most accurate information on our website. Sometimes we get mistakes in product information sent from vendors such as typos. We can not be responsible for these typos, if you see something that does not look right please let us know before ordering so we can double check for you first. LMPerformance will not pay for typos in any way, monetarily or otherwise.
Price Errors: In the event that a product has mistakenly been listed at an incorrect price, We reserve the right to refuse or cancel any orders placed for product listed at the incorrect price. We reserve the right to refuse or cancel any such orders whether or not the order has been confirmed and your account charged. If your payment type has already been charged for the purchase and your order is cancelled, a full refund to your orignial payment method in the amount of the incorrect price will be issued.
Special Order ITEMS: Some items are Special Ordered and may not be returnable, or even cancellable as they are going into production specifically because you ordered them. Special Ordered items can have a 5-35% cancelation fee.
Cancellations: Instock orders cannot be canceled due to our automated ordering & fast shipping system. To keep our prices low, all cancelations are subject to a 5% cancelation fee to cover transaction processing fees. We reserve the right to charge up to a 10% cancellation fee for cancelled orders due to merchant fees, Special Order fees and the cost of processing and shipping orders.When you request a cancellation of an order or a part, please note that it may take time for a manufacturer to cancel an order if the order is drop-shipped. We also have to confirm that the product has not shipped. If the product has shipped then this must be processed as a return.Also note that sometimes products ship more quickly than expected, so we recommend that you do not purchase alternative products until receiving final confirmation of the cancellation.
Returns: We cannot accept returns on parts that have been used or installed. No returns will be accepted after 30 days. All Returns must be in original packaging. Prior authorization must be given before any return can be made. Up to a 25% Restocking Fee may apply. Special Orders may be subject to Additional Manufacturer Restock Fees as well. Shipping cost will not be refunded.Hoods as well as PCM Programmers may not be returned unless defective and only for replacement. ALL returns must be first filed using our online form found here: https://www.lmperformance.com/returns.
Lost Order Claims All lost order/package claims must be made within 5 days of the shipping date or tracking information delivery date. All claimes made after this date will not be accepted due to Shipping companies policies of filing loss claims.
Damaged Items or Incorrect Items: Please contact us right away if your item has been damaged in shipping or are incorrect. Please note that we will ship replacement items the same method of shipping the order was originally placed for. LMPerformance can not ship packages overnight at our cost if the original shipping was not also overnight. Claims must be filed in order for replacement parts to be shipped.
Warranties:Any warranty claims must be placed with the manufacturer. All of the products sold by LMPerformance, regardless of the manufacturer, are designed for Racing and Performance applications. Many of our manufacturers offer NO WARRANTY on their products, either stated or implied, due to the unusual stresses placed on the parts and because we have no control over how they are installed and used. Many of these products are designed for off-road use only and are not legal for use on public highways. If you have a question about the warranty on a specific product, please e-mail or call us. Buyer assumes all risk and liability associated with these products.
Installation: We are not responsible for or any costs associated with the installation or the improper installation of any products. Purchaser assumes the risk associated with the installation of products. We, along with the manufacturer of each product are not responsible for any direct or indirect damage to the vehicle, personal, or costs incurred from the use of products.