866.567.2001

Audi TT Borla Exhaust

<< FIRST < PREV ...   NEXT > LAST >>
  • Audi TT Borla Exhaust
  • SELECT CATEGORY
  • Borla Exhaust PRODUCT LINE(S)
  • SELECT BRAND
  • Audi TT Borla Exhaust
SORT BY:
VIEW:
<< FIRST < PREV ...   NEXT > LAST >>
Borla Exhaust

Borla Exhaust

About Borla Exhaust

Borla Exhaust Systems are the pacesetter in the manufacture and design of high performance Borla exhaust systems, header and induction systems and as a consequence are sui generis in three ways: 1) manufactured from exotic materials, such as state- of- the art 304 stainless steel, titanium and carbon fiber; 2) the warranty outlasts the vehicle's life; and 3) the muffler design allows for a bolt-on and uncomplicated fit.

Every Borla Cat-Back System, Borla Header and Rear Section Exhaust is constructed of aircraft-quality authenticate stainless steel and is stainless inside and out and utilizes T-304 stainless steel because it is the most resistant to corrosion culminating in a long-lasting and resilient exhaust system. Bigger is not always better because big pipes can divest the exhaust of energy and additionally big pipes aggrandize the low frequencies culminating in uncomfortable roaring or droning sound. The Borla exhaust system & Borla Muffler are less restrictive and preserves the velocity and high frequency so the dominant sound is behind the tailpipe where it belongs and in addition to that Borla's sui generis Intercooled Tips have an idiosyncratic look and are seen ubiquitously on show and street cars providing your vehicle with the same idiosyncratic look as these winners.

If the above acclaimed reasons for buying a Borla Muffler or Borla Exhaust system are not sufficient then consider that the installation for the do-it-yourselfer should conceivably take about two hours for a system install and about six hours for header installation and this is just another accolade for these parts and a reason for you to purchase them.

Borla Exhaust Systems have a compilation of emission legal exhausts that are the largest in the industry and Borla's Million Mile warranty is the most compendious of any exhaust supplier. Borla exhaust mufflers will stand behind your performance exhaust product longer than you will be driving your car and that is a commitment you can depend on.

Longevity is not the only thing that recommends Borla exhaust mufflers as your choice when it comes to a performance exhaust system even though you cannot forget about the fact that they have been manufacturing premium exhaust systems for three decades and they have their roots in the manufacturing of parts for the iconic Rolls-Royce and Ferrari, names that speak for themselves. Their solid reputation in the aftermarket performance parts industry is second to none when it comes to exhaust products and they have achieved this reputation by providing only exemplary products for street, off-road and racing applications and their diligence of quality production is the same for all three. Borla mufflers and Borla exhaust systems are able to do this because they have invested in a facility that is outstanding in every way and includes an avant-garde test and development center focused on improvement in all areas and have been instrumental in improving the design of aftermarket performance exhausts. All of this effort is not without its rewards and they have been awarded “BEST NEW PRODUCT” in the industry on more than one occasion, something to be extremely proud of. The top engine builders in racing can’t all be wrong when they choose BORLA exhaust systems & Borla Mufflers and neither will you be when you choose BORLA Pipes. We also offer other great parts with these Corsa Performance Exhaust Systems.

Audi

These are some of the items you can find at LMPerformance for your Audi

Progress through Technology- is the company ethos and is the core belief that drives the development of every Audi vehicle and if you are the proud owner of an Audi you deserve the best for your vehicle and Late Model Performance wants to help you get what you deserve.

LMPerformance is proud to offer high quality exhaust systems for your Audi by B&B (Billy Boat) Exhausts. B&B Systems feature an exotic sound that is never too loud. B&B Exhausts are made in the USA and are constructed of high Quality 304 Stainless Steel.

The Sport Lowering Springs from B & G Suspension for your Audi 200, 4000, 5000, 80. 90, A3, A4, A5, A6, A8, S4, S5, S6 and TT can give your Audi that race car look but as an added incentive to make the change consider the fact that they will promote better handling and road holding because you are reducing the distance between your car and the floor and as a consequence are altering the air flow under the car. The B&G springs are manufactured to the high standards you want in lowering springs so that they are long lasting and corrosion resistant.

Washable and reusable filters from the inimitable K & N can be beneficial in increasing horsepower in your Audi but consider that with the addition of an air intake system you can eliminate air restrictions built into your factory system for even greater results. The 57 series air intake systems for your A3, Quattro and TT will produce a marked improvement in your engine’s performance and you won’t be disappointed in your decision to make this change. The K&N Performance Kit for your A3, A4, Quattro and TT; the International Kit for the A3, A4, A6, RS4, TT, A6, A3 all have an oversized air filter and are attached to rotationally molded tubes of High Density Polyethylene g for precise shaping so that there is a resultant reduction in turbulence and freer path for air flow into your Audi engine.

Replacing your clutch either out of necessity, improvement or just racing fun will be worth the investment with an outstanding clutch from SPEC. The SPEC products are available as full Clutch Kits, Clutch Disks and Clutch Pressure Plates for your Audi and because SPEC knows not all drivers are alike they offer you a multiplicity of choices for your new clutch so that you can match your clutch to your driving needs rather than matching your driving to your clutch’s needs. Also for the discriminating buyer we have the SPEC billet flywheels, manufactured to the highest standards with a .001 machine tolerance for a perfect seating surface on your Audi clutch for those who need a lighter weight flywheel for their driving demands.

For even more improved performance replace your OEM shocks with the premier high performance shocks from KONI. The KONI shocks and shock and spring kits and are obtainable in the yellow sport that can be used with spring kits, the orange street, and the FSD Gold that adjust automatically to road conditions. KONI Coil Over Kits for your Audi TT, A3 and A4 are an enhancement to your Audi because they produce better road holding and a captivating look and the give you the ability to individualize your ride height. KONI is known worldwide for the manufacture of performance and adjustable shocks that are of superlative quality.

Installing the EIBACH Sway Bar Kit to your Audi A3 will fine-tune the performance handling of your car, reduce body roll and result in improved corner gripping and since it is manufactured by the prestigious EIBACH company you get a million-mile warranty because they believe in their product. Or, better yet, consider the Sport-Plus for your Audi A3 that includes the EIBACH SPORTLINE Springs and Anti-Roll Kit Sway Bars so that you reduce squat during acceleration, body roll and excessive nose-dive. Consider Coil-Over Kits for your A3, A4, S4 and TT to get your Audi looking and performing its best or install lowering kits on your A3, A4, A5, A6, S4, S5 and TT to lower your car's center of gravity resulting in high performance and an extremely low and comfortable ride- all from the prestigious manufacturer EIBACH.

Whether out of necessity because of repair, for improvement in appearance, or for aerodynamics in racing, choosing body parts can be overwhelming.

but with extraordinary manufacturers like Seibon and Duraflex the job is easy. Seibon Carbon components are made of high-quality carbon fiber and whether it be trunk panels for your A4 and A8, Hoods for your A3, A4, A5, A8 or TT, or Rear Wings for your TT you will get the best with Seibon because every part has an exceptional carbon/resin ration for extra strength and comes with a glossy clear coat. The eminent manufacturer Duraflex can indulge your Audi with Body Kits, Bumpers, Rear Lips, Front Spoilers, Door Caps, Fender Flares, Grilles, Hoods, Rear Wings, Side Scoops, Side Skirts and Trunk Panels fabricated from its extraordinary composite of fiberglass, plastic and resins that present you with a product that is eminently more durable at an affordable price and ready for a paint job because they come primed.

^

LM Performance Shopper Approved Reviews